protecting industrial frp and pvc walls from staining and de-lamination

FRP and PVC walls are used in industrial, high hygiene, food processing applications.

but they do not last forever. protection can enhance their lifecycle.

FRP WALLS STAIN AND BECOME DIFFICULT TO CLEAN DUE TO :

  • ORGANIC EXPOSURE, SUCH AS GREASE, OIL, BLOOD, FOOD INGREDIENTS

  • PANELS (FRP, PVC) NOT CAULKED FOR PROPER SEALING AS PART OF ORIGINAL CONSTRUCTION

  • PRESSURE WASHING EXCEEDING 150-300 PSI

  • NOT USING A BRUSH TO WET CLEAN, AND THEN USING HIGHER AND HIGHER PRESSURE LEVELS

  • HARMFUL SANITATION CHEMICAL CONSUMPTION INCREASING. THIS DESTROYS THE PROTECTIVE COATING ON THE FRP AND PVC PANELS

  • DE-LAMINATION FROM SUBSTRATE, CAUSED BY FAILED CAULKING OR WATER BEING PUSHED “BEHIND” FRP PANELS, AND WEAKENING THE ADHESIVE BOND

SUREBOND CAN HELP IN THE FOLLOWING WAY:

  • INSTALLING FRP OR PVC PANELS

  • SEALING ALL CORNER AND VERTICAL JOINTS WITH OUR MMA FLOORING RESIN, SO WATER CANNOT GET BEHIND THE PANELS

  • PRE-COATING ALL FRP PANELS WITH OUR SEALING MMA RESIN IN OUR SHOP. SUREBOND CAN “SUPPLY ONLY” THE PANELS, OR “SUPPLY AND INSTALL” THE PRE-COATED PANELS

  • REJUVENATION OF INSTALLED FRP PANELS IN GOOD SHAPE CAN OCCUR, YEARS AFTER ORIGINAL INSTALLATION

  • MOISTURE MITIGATION SOLUTIONS

This scaled model is 100% sealed with Silikal® resin. All vertical corners and joints: are permanently sealed. The FRP is also been sealed over the entire sheet before installation. We have coved on the bottom on top of our Silikal® R62 flake floo

This scaled model is 100% sealed with Silikal® resin. All vertical corners and joints: are permanently sealed. The FRP is also been sealed over the entire sheet before installation. We have coved on the bottom on top of our Silikal® R62 flake floor. 100% sealed, permanently. This should extend the life of the FRP dramatically and reduce the risk of delamination from the wood substrate behind.

Left side of image is the FRP from the factory. Right side of image show the coverage depth of the Silikal® on the FRP panel. We can coat the joints days, weeks, months later once the FRP is installed in the final plant location.

Left side of image is the FRP from the factory. Right side of image show the coverage depth of the Silikal® on the FRP panel. We can coat the joints days, weeks, months later once the FRP is installed in the final plant location.